FLASH: Thanks John- now another question about motion paths not working

[Sienna]

Thanks about the flying text tutorial.  My brain hurts looking at it for

now.  :)


Ok here's my next problem, I have to make a company name follow in a

circle.  Each letter is on it's own layer, but they all have to follow the

same motion path.  I made the path (a circle) then dragged each letter

layer under the path so they all are linked to the same circle path.


For the first letter; I entered a keyframe, dragged the letter around the

circle and stopped on the other side of the circle just short of its

original starting point.  When I tween the frames, the letter won't follow

the circle.  It goes backwards a little bit and stops.  Why?


I need the whole line of text to continue in  a rotating circle.  What am I

doing wrong?  I tried to follow the MM tutorial with the 2 boats going in a

circle path but it's not working for the letters.


Thanks again.


Sienna


P.S.  Hi Scott, welcome to the list.  If you figure this one out before me,

come down to my office and help me before I have to turn in my project! LOL




flasher is generously supported by...

~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~

Streaming Media WEST '99 Conference & Exhibition

"The Worlds largest Internet Audio & Video Event"

December 7 - 9, San Jose Convention Center, California


Reserve your space today at http://www.streamingmedia.com

~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~

To unsubscribe or change your list settings go to

http://www.chinwag.com/flasher or email

helpchinwag [dot] com