[Previous]
[Next]
- [Index] [Thread Index] - [Previous in Thread]
[Next in Thread]
| Subject: |
Re: FLASH: a quest�on of edges |
| From: |
Phil Ward |
| Date: |
Wed, 6 Oct 1999 10:33:38 +0100 |
|
You need to set the page borders to 0 add this to your
htm
<body bgcolor="#FFFFFF" marginwidth="0" marginheight="0"
topmargin="0" leftmargin="0">
Regards
Phil Ward
Crescent Graphics
phil-w crescent-graphics [dot] co [dot] uk
New Media <> Internet <> Visuals <> A/W
----- Original Message -----
Sent: 06 October 1999 09:59
Subject: FLASH: a questıon of edges
Hi all,
I have a small
problem I have logo that ideally would sit on the left hand edge of my
shockwave file actually touching the edge of the document on the left(I think
you get the idea)
anyway I am unable to achieve this as every
time I publish or test this file it sits it not on the edge but about 5cm away
I have tried the publisher setting(Flash 4 by the way) aligning right and
all that although it is on the edge in the stage it does not do as I
wish......any ideas I am using a flash document set at 100% H and width for a
800x600 stage I thought it would scale the stage and fit into window but
instead it appears to place it in the middle?????Is this all because of my
monitor settings 1024x768 but I thought the idea of scaling was just that it
should scale?????
I once again hope this makes sense thanks
in advance to the guru's
Stuart
|
Replies
FLASH: a questıon of edges, stuart mayhew
[Previous]
[Next]
- [Index] [Thread Index] - [Next in Thread]
[Previous in Thread]
